General commands
show ports
Show information about ports
config ports X state enable
Enable port X
config ports X state disable
Disable port X
config bandwidth_control <portlist> rx_rate <value 1-1000> tx_rate <value 1-1000>
Change port speed
config vlan default(vlan name) delete xx config vlan v996 (vlan name) add untagged xx
Change vlan
show switch
Show information about switch
show log
Show switch log
show ports description
Show ports description field
config ports X description
Add port X description
show arpentry
Show arp-cache.
show fdb port X
Showing port MAC-addresses on port X
show fdb mac_address <MAC-address>
show packet ports portnumber
Show traffic statistics for portnumber. RX – received packets from client, TX – transmitted packets to client.
show utilization cpu
Show cpu utilization for 5 seconds, 1 minute, 5 minuts.
show utilization ports
Show ports utilization in PPS (packets per second)
show ipif
Shows configured ip-interfaces on switch
show iproute
Show switch ip routing table
sh fdb
Show all ip interfaces and all devices
MAC-addresses connected to switch
show error ports portnumber
Show errors on selected portnum
Error types
- CRC Error –
- Undersize –
- Oversize
- Jabber
- Drop pkts
- Fragment
- Excessive Deferral
- Collision
- Late collision
- Excessive Collision
- Single Collision
Additional commands
show traffic control
show mac_notification
show port_security
show stp
show arpentry ipaddress <IP-address>
show dhcp_relay
show vlan
show lldp remote_ports
Similar Posts:
1,465